Description
80 Litres in Store. 40 Litres Cooled Every Hour.
AUS J1 stainless steel · 2 taps · 35mm PUF insulation.
Up to 200 glasses per hour · serves approximately 80–100 people · hermetically sealed reciprocating compressor with fin & tube condenser · 10°C–25°C water temperature · 460mm slim depth · 1 year comprehensive warranty
The number that decides whether a water cooler works in a real building is the storage tank, not the compressor. At 11:30 on a June morning in Delhi, a school corridor or a factory shop floor does not draw water at a steady rate — it draws forty glasses in four minutes. An 80-litre reservoir of already-chilled water absorbs that surge without the temperature climbing, while the 40 LPH refrigeration keeps refilling behind it. That is what lets this unit serve up to 200 glasses an hour and roughly 80–100 people through a full working day, break after break, right through the peak of a 45°C summer.
Hermetically sealed reciprocating compressor with fin & tube condenser
A commercial cooler runs for ten to twelve hours a day, every working day, in ambient heat that would flatten a domestic appliance. Voltas builds this one around a hermetically sealed reciprocating compressor — a sealed system, so the refrigerant circuit stays clean and there is no shaft seal to leak over the years — paired with a fin and tube condenser that sheds heat efficiently even when the surrounding air is already hot. Behind them sits 35 mm of in-situ PUF insulation, foamed in place so it fills the cavity completely rather than being cut and fitted. That insulation is what holds the cold between draws: the compressor cycles less often, the electricity bill is lower, and the water is at 10°C–25°C whenever a tap opens.
AUS J1 stainless steel where the water actually touches
Delhi NCR runs on borewell and tanker supply, and that water is hard. Over a few summers it will find any weakness in a tank, a faucet or a drip trough. This Voltas uses AUS J1 stainless steel for exactly those critical parts — the tank, the taps and the trough — so there is no corrosion path and nothing to taint the taste of the water. It wipes clean, it stands up to daily institutional use, and it holds the hygiene standard a hospital, a canteen or a school actually needs. The outer body is stainless steel too, so the unit still looks presentable in a reception area or a corridor after years on duty.
🏢 Where this one earns its keep
Schools & Colleges
80L of chilled water absorbs the whole-corridor rush at every break bell
Hospitals & Clinics
Stainless steel tank, taps and trough for a hygiene-first environment
Factories
Built for heavy-duty shift use on a hot shop floor
Offices & Public Spaces
Two taps keep the queue moving in pantries, lobbies and community halls
🎛️ How it is built
80 L Stainless Steel
AUS J1 stainless steel reservoir keeps a deep buffer of chilled water ready
40 LPH Refrigeration
Sealed reciprocating compressor and fin & tube condenser, chilling continuously
35 mm PUF
In-situ foam insulation retains the cold and cuts compressor load
2 Taps
Two people fill at once — the queue halves at every break
🛠️ Specified for institutional duty
At 460 mm deep it sits flat against a corridor wall or a factory pillar without becoming an obstruction, despite carrying 80 litres.
The refrigeration keeps working while people are drinking. Through a Delhi summer shift, that means the last person in the queue at 3 PM gets water as cold as the first person at 9 AM — the tank never runs down to lukewarm.
Dual dispensing is the single most practical feature in a high-footfall building. Two people fill at once, so a fifteen-minute break bell in a school or a factory does not turn into a five-minute line at the cooler.
Foamed in place rather than cut to fit, the PUF layer holds cold water cold between draws. Fewer compressor cycles means lower running cost and less wear — the difference shows up on the electricity bill every month.
582 × 1460 × 460 mm floor-standing form. High capacity in a body narrow enough for a corridor, a waiting area or a staff pantry where floor space is already spoken for.
| Brand / Model | Voltas WC FS 40/80 NP ✅ |
| Product Type | Commercial Water Cooler · Floor Standing ✅ |
| Cooling Capacity | 40 Litres Per Hour ✅ |
| Storage Capacity | 80 Litres ✅ |
| Dispensing Capacity | Up to 200 glasses per hour ✅ |
| Suggested Usage | Approx. 80–100 people ✅ |
| Compressor | Hermetically Sealed Reciprocating ✅ |
| Condenser | Fin & Tube ✅ |
| Insulation | In-Situ PUF · 35 mm thickness ✅ |
| Number of Taps | 2 ✅ |
| Water Temperature Range | 10°C – 25°C ✅ |
| Tank, Faucets & Trough | AUS J1 Stainless Steel ✅ |
| Outer Body | Stainless Steel ✅ |
| Dimensions (W×H×D) | 582 × 1460 × 460 mm ✅ |
| In the Box | Water Cooler · User Manual · Warranty Card ✅ |
| Country of Origin | Made in India 🇮🇳 ✅ |
| Warranty | 1 Year Comprehensive ✅ |
Why buy from Mahajan Electronics?
- Since 1981 — 45+ years of trust in appliances
- 24-hour delivery across Delhi NCR
- GST invoice — save up to 18% on business purchases
- Mahajan seller invoice for your warranty record
- We size the cooler to your headcount before you buy
- Raja Garden · Jail Road · Dabri Mor
Order today. Delivered in 24 hours.
Voltas WC FS 40/80 NP · 80L Storage · 40 LPH Cooling · 2 Taps · AUS J1 Stainless Steel · 35mm PUF Insulation · Up to 200 Glasses/Hour · Made in India · 1 Year Comprehensive Warranty
Image for reference only.
